Konica Minolta magicolor 4750EN/4750DN magicolor 4750EN/magicolor 4750DN User - Page 112

THICK MODE Settings QUALITY MODE / SPEED MODE In order to prevent toner from clogging within the developer unit as a result of it being driven at half-speed, select the timing for driving the developer unit at full speed for a fixed length of time when thick paper is being fed. QUALITY MODE: While printing on thick paper, printing is periodically paused, and the developer unit is driven at full speed for a fixed length of time. Since printing is paused, the quality is not affected; however, a standby time of approximately 70 seconds occurs every 400 seconds or so of half-speed operation. SPEED MODE: While printing on thick paper, only the drive of the developer unit periodically switches to full speed for a fixed length of time. Since printing continues during full-speed drive, the print quality is slightly affected, however the standby time is short. ENGINE ENGINE Settings ON / OFF DIPSW DIPSW 1-28 Use to change engine settings. " Normally, there is no need to change the settings. If it becomes necessary to change the settings, do so according to the instructions from Technical Support. MAIN MAIN Settings PRINT / CANCEL SCAN SCAN ADJUST PAGE Print the test pattern for fine adjustment of the color ratios in the main scanning direction. SCAN YELLOW Settings 42 - 0 - -42 ADJUST VALUE Finely adjust the ratio of yellow in the main scanning direction. MAGENTA Settings 42 - 0 - -42 CYAN Finely adjust the ratio of magenta in the main scanning direction. Settings 42 - 0 - -42 Finely adjust the ratio of cyan in the main scanning direction. Configuration Menu Overview 4-69