Kyocera KM-1650 1650/2050/2550 Operation Guide Rev-4 (Basic) - Page 43
Connecting the Cables
View all Kyocera KM-1650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Preparations Connecting the Cables This machine can be connected either to a network or directly to a single computer. This section describes the procedures to make both types of connection. Connecting the Network Cable To connect this machine to a network, use an Ethernet cable (10Base-T or 100Base-TX). 1 Open the main power switch cover located on the right side of the machine, turn the main power switch off ({), and remove the power cord from the outlet. 2 Connect the network cable to the network interface connector at the right side of the machine. 3 Connect the other end of the network cable to your network device (hub). 4 Make network settings. (See page 2-15.) Connecting the Printer Cable To connect the machine directly to your computer, use either a parallel cable or a USB cable. Important! Be sure to turn the main power switch of this machine off before connecting the printer cable. 1 Open the main power switch cover located on the right side of the machine, turn the main power switch off ({), and remove the power cord from the outlet. Turn the power of your computer off. 2-11