Kyocera KM-1820 1820 Operation Guide (Basic Edition) Rev-1.1 - Page 73
Message, Procedure, Reference, Auto Error Clear - scan to computer 1102
View all Kyocera KM-1820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Troubleshooting Message Replace Toner. Scan memory overflow. Job is canceled. Send error. #### Procedure Toner has run out so further copying or printing is impossible. Replace the toner container using a new toner kit. Press right Select to cancel the copying procedure. The total amount of data received by the machine exceeds the machine's internal memory. To verify the current amount of memory, print out a Status Page. To cancel printing, press right Select. If Auto Error Clear is set to On, printing will be automatically resumed after a preset period of time. Lower the image quality. An error has occurred during transmission. The possible error codes and their descriptions are as follows. 1101: The server name of the SMTP server is not set correctly or the host name is incorrect when sending scan data to an FTP server. Use COMMAND CENTER and register the SMTP server name and the host name correctly. 1102: The login user name is incorrect or the domain name has not been entered. Enter login name, domain name and password correctly. 1103: The network path name is incorrect or you do not have access to the folder specified. Use COMMAND CENTER and register the path name correctly. 1104: No recipient address. Enter e-mail address correctly. 1105: E-mail - The SMTP protocol setting is turned off. Use COMMAND CENTER and turn on the SMTP protocol setting. Scan to PC (SMB) - SMB setting is turned off. Use COMMAND CENTER and turn on the SMB setting. Scan to PC (FTP) - FTP setting is turned off. Use COMMAND CENTER and turn on the FTP setting. 1106: The sender address setting under e-mail: SMTP is not registered. Use COMMAND CENTER and register the sender address. 210#: The network cable is disconnected or the hub that it is connected to is not operating properly. Check the cable connection or the hub. The server name or the host name of the SMTP server is not set correctly. Use COMMAND CENTER and register the SMTP server name and the host name correctly. 220#: The network cable has become disconnected during transmission or the hub that it is connected to has stopped operating. Check the cable connection or the hub. Reference page 5-1 page 4-3, Advanced Operation Guide Advanced Operation Guide page 4-11 Advanced Operation Guide page 4-9 Advanced Operation Guide Advanced Operation Guide page 3-1 Advanced Operation Guide page 3-1 OPERATION GUIDE 6-5