LG LREL6321S Owners Manual - Page 17
Wire Connection: Conduit, Wire Connection: Conduit
View all LG LREL6321S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
ENGLISH 3-Wire Connection: Conduit Install the conduit as follows: Remove the conduit connection plate from the rear of the oven and rotate it. The conduit hole (11/8") must be used. First, prepare the conduit wires as shown below. 3-Wire 4-Wire Conduit or connection plate Ground wire Second, install the conduit strain relief. For conduit installations, purchase a strain relief and insert it in the 11/8 in. (2.8 cm) conduit hole. Then install the conduit through the body of the strain relief and fasten the strain relief with its ring. Reinstall the bracket. For conduit connections: If the wire in the conduit is copper it must be 8 or 10 AWG wiring. If the wire in the conduit is aluminum it must be 6 or 8 AWG wiring. 1 Loosen the lower 3 screws from the terminal block. 2 Insert the bare wire (white/neutral) end through the center terminal block opening. Do not remove the ground strap connections. 3 Insert the two side bare wire ends into the lower left and the lower right terminal block openings. Tighten the 3 screws securely into the terminal block. (approximately 35 - 50 IN-LB) 3-wire connection Black White Red Terminal block Wire ends INSTALLATION 17 4-Wire Connection: Conduit WARNING •• The white middle (neutral) wire of the power cord or 4-wire conduit has to be connected to the middle post of the main terminal block. The other two wires of the power cord or conduit have to be connected to the outside posts of the main terminal connection block. The 4th ground wire (green) must be connected to the frame of the range with the ground screw. Failure to do so can result in electrical shock, severe personal injury or death. 1 Follow the instructions for installing the conduit under 3-Wire Connection: Conduit until the strain relief and bracket are installed. Do not install the conduit without a strain relief. 2 Loosen the 2 lower left and right screws from the terminal block. Remove the lower 2 center screws. Do not discard any screws. 3 Remove the ground screw and bend the end of the ground strap up so the slot is over the hole of the center screw removed in step 1. 4 Attach the ground (green) bare wire end to the range frame and secure it in place with the ground screw. 5 Insert the bare wire (white/neutral) end through the center terminal block opening. The center screw now attaches the bent up ground strap to the block. 6 Insert the two side bare wire ends into the left and the right terminal block openings. Tighten the 3 screws securely into the terminal block. (approximately 35 - 50 IN-LB) 4-wire connection Black White Red Wire ends Conduit connection plate Terminal block Ground strap Bend strap up and attach Conduit connection plate If screws are not tightened securely, it can result in electrical spark and severe personal injury or death. Ground screw Ground wire If screws are not tightened securely, it can result in electrical spark and severe personal injury or death.