Lenovo 42962YU User Manual - Page 54
Beep symptoms, Table 3. Error messages continued, Table 4. Beep symptoms
View all Lenovo 42962YU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Table 3. Error messages (continued) Symptom or error Cannot boot from any device. FRU or action, in sequence Check the status of device which you want to boot from. Device not found. 1. The device you want to boot from. 2. System board. Device Error. 1. The device you want to boot from. 2. System board. No valid operating system. 1. Check that the operating system has no failure and is installed correctly. 2. Reinstall the operation system. Excluded from boot order. • Enter the BIOS Setup Utility and add the device in boot order. Beep symptoms Table 4. Beep symptoms Symptom or error FRU or action, in sequence One beep and a blank, unreadable, or flashing LCD. 1. Reseat the LCD connector. 2. LCD assembly. 3. External CRT. 4. System board. One long and two short beeps, and a blank or unreadable LCD. 1. System board. 2. LCD assembly. 3. DIMM. Two short beeps with error codes. POST error. See "Numeric error codes" on page 43. Two short beeps and a blank screen. 1. System board. 2. DIMM. Two or more beeps, or a continuous beep. Operating system starts successfully. If a mini-PCI Ethernet card is installed, confirm that Alert On LAN 2 in BIOS Setup Utility is disabled. Three short beeps, pause, three more short beeps, and one short beep. 1. DIMM. 2. System board. One short beep, pause, three short beeps, pause, three more short beeps, and one short beep. Only the cursor appears. Reinstall the operating system. Four cycles of four short beeps and a blank screen. System board (security chip) Five short beeps and a blank screen. System board 48 ThinkPad X220 Tablet and X220i Tablet Hardware Maintenance Manual