Lenovo ThinkCentre A58e Hardware Maintenance Manual - Page 85

Replacing the hard disk drive

Get Lenovo ThinkCentre A58e PDF manuals and user guides View all Lenovo ThinkCentre A58e manuals
Add to My Manuals
Save this manual to your list of manuals

Page 85 highlights

Figure 10. Installing the memory module 8. Reinstall any parts and reconnect any cables that have been removed. 9. Go to "Completing the FRU replacement" on page 84. Replacing the hard disk drive Attention Do not open your computer or attempt any repair before reading and understanding the "Important safety information" in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to: http://www.lenovo.com/support This section provides instructions on how to replace the hard disk drive. To replace the hard disk drive, do the following: 1. Remove the computer cover. See "Removing the computer cover" on page 67. 2. Locate the primary hard disk drive.. Note: There is also a secondary hard disk drive bay for you to install a secondary hard disk drive by yourself. If you want to install a secondary hard disk drive, use the same way of installing the primary hard disk drive. 3. Disconnect the signal cable and the power cable from the rear of the hard disk drive. 4. Remove the four screws that secure the hard disk drive. Then, slide the hard disk drive out of the chassis. Chapter 8. Replacing FRUs (Type 0841) 79

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
Figure 10. Installing the memory module
8.
Reinstall any parts and reconnect any cables that have been removed.
9.
Go to “Completing the FRU replacement” on page 84.
Replacing the hard disk drive
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the
ThinkCentre Safety and Warranty Guide
that came with your computer. To obtain a copy of the
ThinkCentre
Safety and Warranty Guide
, go to:
This section provides instructions on how to replace the hard disk drive.
To replace the hard disk drive, do the following:
1.
Remove the computer cover. See “Removing the computer cover” on page 67.
2.
Locate the primary hard disk drive..
Note:
There is also a secondary hard disk drive bay for you to install a secondary hard disk drive by
yourself. If you want to install a secondary hard disk drive, use the same way of installing the primary
hard disk drive.
3.
Disconnect the signal cable and the power cable from the rear of the hard disk drive.
4.
Remove the four screws that secure the hard disk drive. Then, slide the hard disk drive out of the chassis.
Chapter 8
.
Replacing FRUs (Type 0841)
79