Magnavox MBP5120F User manual, English (US) - Page 36

Network Connection [SETUP]B B"Others"B"Network Connection" Set up network connection settings in order to use BD-Live, VUDU or network update function. Connection Test After you enable a network connection or change the network settings, always perform the connection test to check if the connection is correctly made. 1. In "Network Connection" menu, use [K/L] to select "Connection Test", then press [OK]. Connection test will start automatically and the test result will appear right after the connection test finishes. • "Testing..." : The test is in progress. • "Pass" : Connection test is successfully completed. • "Fail" : Connection test failed. Check the connection settings. If the connection test passes, press [OK]. • Confirmation screen of the network selection will appear. e.g.) Wired connection Others Connection Test Network Selection Wired then press 'OK' . Press [OK] again to display the confirmation screen of network settings. Others Connection Test IP Address Subnet Mask Default Gateway Primary DNS Secondary DNS xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx then press 'OK' . 2. Press [OK] to go back to the previous screen, or press [SETUP] to exit. Note • If the connection test passes, you are ready to use BD-Live, VUDU or network update function using the Internet without making any additional settings. • If the connection test fails, you may need to change the MAC address settings on your router. You can check the MAC address of this unit on "Custom" screen. (Refer to "Custom (Wired)" on page 36.) • When connecting this unit directly to a modem for the first time or connecting it to a modem which was previously connected to any other network device(e.g. a router, PC, etc.), you may have to power cycle the modem to reset the settings on the modem. • "Connection Test" is not available when "Disable" is selected in "Network Connection". Network Selection  Wired Select "Wired" if you made a wired connection and set the setting to "Easy"(wired) or "Custom"(wired), in accordance with your network environment. Network settings are set to the following settings initially. (In most cases, you can connect to the Internet without making any changes to the default settings.) - IP Address Setting Auto(DHCP) - DNS Setting Auto(DHCP) - Proxy Setting Do Not Use - Connection Speed Auto - BD-Live Setting Allow If you want to set the network settings back to the default settings as above (except "BD-Live Setting"), follow the procedure below. 1. In "Network Connection" menu, use [K/L] to select "Network Selection", then press [OK]. 2. Use [K/L] to select "Wired", then press [OK]. 3. Use [K/L] to select "Easy", then press [OK]. • The unit will start the connection test automatically and the test result will appear right after the test finishes. 4. Press [OK] to activate the network settings and set the network connection automatically. Press [SETUP] to exit. Note • The setting of "BD-Live Setting" will not be set back to the default, even if you follow the procedure. In following cases, select "Custom"(wired) to set each setting as necessary. - When connection test failed with the setting of "Easy"(wired). - When instructed by your Internet service provider to make specific settings in accordance with your network environment. To set the network setting to "Custom"(wired), follow the following procedure. 36