Marantz SR5008 Owner's Manual in English - Page 161

Contents Connections Playback 3 Connect the Setup and measurement microphone to the SETUP MIC jack of this unit. When the Setup and measurement microphone is connected, the following screen is displayed. Audyssey Setup Your AV receiver can automatically measure the acoustics of your room then optimize your speakers using the included microphone. Set the following items if necessary. Amp Assign Channel Select Check Results Restore... Start Settings Tips Appendix 4 Select "Start" and then press ENTER. Audyssey® Setup can also make the following settings. • Amp Assign The signal output from the SURROUND BACK speaker terminals of this unit can be switched to match your speaker environment. Refer to "Amp Assign" (vpage 167). • Channel Select If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers. 5 Select "Next" and then press ENTER. 6 Select "Begin Test" and then press ENTER. • Measurement requires several minutes. NOTE • If "Caution!" is displayed on TV screen: Go to "Error messages" (vpage 165). Check any related items, and perform the necessary procedures. When measuring has stopped q Press BACK to display the popup screen. w Press o to select "Yes", and then press ENTER. Front panel Display Rear panel 161 Remote Index