Marantz SR5008 Owner's Manual in English - Page 192

Contents Connections Playback Settings Tips Appendix Symptom Cause / Solution DTS sound is not output. • Check that the digital audio output setting on the connected device is set to "DTS". • Set "Decode Mode" on the menu to "Auto" or "DTS". Dolby TrueHD, DTS-HD, Dolby Digital • Make HDMI connections. Plus audio is not output. • Check the digital audio output setting on the connected device. On some devices, "PCM" is set by default. Dolby PLg mode or DTS NEO:6 mode • It cannot be selected when "None" is set for "Speaker Config." - "Center" and "Surround". cannot be selected. • These cannot be selected when using the headphones. Audyssey MultEQ® XT, Audyssey Dynamic EQ® and Audyssey Dynamic Volume® cannot be selected. • These cannot be selected when you have not performed Audyssey® Setup. • Switch the sound mode to other than "DIRECT" or "PURE DIRECT". • These cannot be selected when using the headphones. • These cannot be selected when an HD audio format with a sampling frequency of over 96 kHz is input (such as may be found on select Dolby TrueHD and DTS-HD discs). "M-DAX" cannot be selected. • Check that an analog signal or PCM signal (Sample Rate=44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS surround, "M-DAX" cannot be used. • Switch the sound mode to other than "DIRECT" or "PURE DIRECT". Page - 157 37, 38, 39 - 168 - 158 109 - - 143 109 Front panel Display Rear panel 192 Remote Index