Marantz SR5008 Owner's Manual in English - Page 191

Contents Connections Playback Settings Tips Appendix 22Desired sound does not come out Symptom Cause / Solution Page The volume does not increase. • The maximum volume is set too low. Set the maximum volume using "Limit"on the menu. • Appropriate volume correction processing is performed according to the input audio format and settings, so the volume may not reach the upper limit. 144, 178 - No sound comes out with the HDMI connection. • Check the connection of the HDMI connectors. 33, 34, 37, 38, 39 • When outputting HDMI audio from the speakers, set "HDMI Audio Out" on the menu to 149 "AVR". To output from the TV, set "TV". • When using the HDMI control function, check that the audio output is set to the AV amplifier 119 on the TV. No sound comes out of a specific speaker. • Check that the speaker cable is properly connected. • Check that a selection other than "None" is set for the "Speaker Config." setting in menu. • Check the "Assign Mode" setting in the menu. • When the sound mode is "STEREO" and "VIRTUAL", audio is only output from the front speakers and subwoofer. 25 168, 169 167 - No sound is produced from subwoofer. • Check the subwoofer connections. 26 • Turn on the subwoofer's power. - • Set "Speaker Config." - "Subwoofer" on the menu to "Yes". 168 • When "Speaker Config." - "Front" in the menu is set to "Large", depending on the input 168 signal and the sound mode, no sound may be output from the subwoofer. • When no subwoofer audio signal (LFE) is included in the input signals, no sound may be 172 output from the subwoofer. • You can make the subwoofer always output sound by setting the subwoofer mode to 172 "LFE+Main". Front panel Display Rear panel 191 Remote Index