McAfee IIP-M65K-ISAA Product Manual - Page 20

Using the redundant power supply, Installing the power supply

Get McAfee IIP-M65K-ISAA - Network Security Platform M-6050 PDF manuals and user guides View all McAfee IIP-M65K-ISAA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

McAfee® IntruShield® IPS 4.1 M-6050 Sensor Product Guide Setting up an M-6050 Using the redundant power supply Using the redundant power supply A basic configuration of the M-6050 includes one hot swappable supply. You may install a second hot-swappable power supply (purchased separately from McAfee) for redundancy. Each of these modules has one handle for insertion or extraction from the unit as well as a release latch. Figure 4: Power supply units Installing the power supply To install a power supply in the M-6050: 1 Unpack the power supply from its shipping carton. 2 Remove the faceplate panel covering the power supply slot. Note: The faceplate panel should remain in place unless a power supply is in the power supply slot. 3 Do not operate the sensor without the faceplate panel in place. 4 Place the power supply in the slot with the cable outlet facing front and on the left side of the faceplate. Figure 5: Power supply installation 5 Slide in the power supply until it makes contact with the backplane, then push firmly to mate the connectors solidly with the backplane. Note: For true redundant operation with the optional redundant power supply, McAfee recommends that you plug each supply into a different power circuit. For optimal protection, use uninterruptable power sources. 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
McAfee® IntruShield® IPS 4.1
Setting up an M-6050
M-6050 Sensor Product Guide
Using the redundant power supply
Using the redundant power supply
A basic configuration of the M-6050 includes one hot swappable supply. You may
install a second hot-swappable power supply (purchased separately from McAfee) for
redundancy.
Each of these modules has one handle for insertion or extraction from the unit as well
as a release latch.
Figure 4: Power supply units
Installing the power supply
To install a power supply in the M-6050:
1
Unpack the power supply from its shipping carton.
2
Remove the faceplate panel covering the power supply slot.
Note:
The faceplate panel should remain in place unless a power supply is in
the power supply slot.
3
Do not operate the sensor without the faceplate panel in place.
4
Place the power supply in the slot with the cable outlet facing front and on the
left side of the faceplate.
Figure 5: Power supply installation
5
Slide in the power supply until it makes contact with the backplane, then push
firmly to mate the connectors solidly with the backplane.
Note:
For true redundant operation with the optional redundant power supply,
McAfee recommends that you plug each supply into a different power circuit. For
optimal protection, use uninterruptable power sources.
12