McAfee IIP-M65K-ISAA Product Manual - Page 23

Installing a module, Removing a module, Power-on the sensor

Get McAfee IIP-M65K-ISAA - Network Security Platform M-6050 PDF manuals and user guides View all McAfee IIP-M65K-ISAA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

McAfee® IntruShield® IPS 4.1 M-6050 Sensor Product Guide Setting up an M-6050 Power-on the sensor Installing a module To install a module with a bail clasp, follow these steps: 1 Remove the module from its protective packaging. 2 Ensure the module is the correct model for your network. 3 Locate the label on the module and ensure that the alignment groove is down. Note: For SFP modules, turn the module so that its label is on top. For XFP modules, turn the module so that its label is on bottom. 4 Grip the sides of the module with your thumb and forefinger and insert module into the module socket. Modules are keyed to prevent incorrect insertion. Figure 8: Module in Monitoring port Removing a module If you are removing a module, follow these steps: 1 Disconnect the network fiber-optic cable from the module. 2 Release the module from the slot by pulling the bail clasp out of its locked position. 3 Slide the module out of the slot. 4 Insert the module plug into the module optical bore for protection. Power-on the sensor Warning: Do not attempt to power on the sensor until you have installed the sensor in a rack, made all necessary network connections, and connected the power cable to the power supply. Connect the power cable to the sensor power supply. Connect the power cable to a power source. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
McAfee® IntruShield® IPS 4.1
Setting up an M-6050
M-6050 Sensor Product Guide
Power-on the sensor
Installing a module
To install a module with a bail clasp, follow these steps:
1
Remove the module from its protective packaging.
2
Ensure the module is the correct model for your network.
3
Locate the label on the module and ensure that the alignment groove is down.
Note:
For SFP modules, turn the module so that its label is on top. For XFP
modules, turn the module so that its label is on bottom.
4
Grip the sides of the module with your thumb and forefinger and insert module
into the module socket.
Modules are keyed to prevent incorrect insertion.
Figure 8: Module in Monitoring port
Removing a module
If you are removing a module, follow these steps:
1
Disconnect the network fiber-optic cable from the module.
2
Release the module from the slot by pulling the bail clasp out of its locked
position.
3
Slide the module out of the slot.
4
Insert the module plug into the module optical bore for protection.
Power-on the sensor
Warning:
Do not attempt to power on the sensor until you have installed the sensor
in a rack, made all necessary network connections, and connected the power cable
to the power supply.
Connect the power cable to the sensor power supply.
Connect the power cable to a power source.
15