Netgear WFS709TP WFS709TP Setup Manual - Page 151
Table 11-1. VRRP Parameters for Local WFS709TP Redundancy, Authentication, Password
UPC - 606449052336
View all Netgear WFS709TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual Table 11-1. VRRP Parameters for Local WFS709TP Redundancy Parameter Virtual Router ID Recommended to Advertisement Interval Authentication Password Description IP Address Enable Router Pre-emption Priority Tracking Explanation Expected or Recommended Values The Virtual Router ID that uniquely Configure this with the same value identifies this VRRP instance. as the VLAN ID for easy administration. The interval between successive Recommended to leave as default VRRP advertisements sent by the (1000ms = 1s). current master. An optional password that can be This is an optional password that used to authenticate VRRP peers can be used to authenticate VRRP in their advertisements. peers in their advertisements. An optional textual description to describe the VRRP instance. The Virtual IP address that will be Configure this with the Virtual IP owned by the elected VRRP address. master. A WFS709TP can take over the role of master if it detects a lower priority WFS709TP currently acting as master. For this topology, it is recommended not to select this option. Priority level of the VRRP instance for the WFS709TP. This value is used in the election mechanism for the master. It is recommended to leave this as the default for this topology (default = 100). Configures a tracking mechanism that adds a specified value to the priority after a WFS709TP has been the master for the VRRP instance. This mechanism is used to avoid failing over to a backup Master for transient failures. Tracking can be based on one of the following: • Master Up Time: how long the switch has been the master. • VRRP Master State Priority: the master state of another VRRP. Recommended to leave this as the default for this topology (default = 100). Configuring Redundancy v1.0, June 2007 11-3