Netgear WFS709TP WFS709TP Setup Manual - Page 37
Deploying a Basic WFS709TP System, Configuration Overview, Deployment Scenario #1 - default ip
UPC - 606449052336
View all Netgear WFS709TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Chapter 2 Deploying a Basic WFS709TP System This chapter describes how to connect a WFS709TP ProSafe Smart Wireless Switch and access points (APs) to your wired network. It includes the following topics: • "Configuration Overview" on page 2-1 • "Configuring the WFS709TP" on page 2-5 • "Deploying APs" on page 2-14 • "Additional Configuration" on page 2-20 Configuration Overview This section describes the tasks you need to perform in connecting a WFS709TP and APs to your wired network in three typical deployment scenarios. Deployment Scenario #1 Router is default gateway for WFS709TP and clients Figure 2-1 In the deployment scenario shown in Figure 2-1, the APs and WFS709TP are on the same subnetwork and will use IP addresses assigned to the subnetwork. There are no routers between the APs and the WFS709TP; APs can be physically connected directly to the WFS709TP. The uplink port on the WFS709TP is connected to a Layer 2 switch or router. You need to perform the following tasks: 1. Run the initial setup (see"Run the Initial Setup" on page 2-6). 2-1 v1.0, June 2007