Netgear WFS709TP WFS709TP Setup Manual - Page 46
Con a VLAN for Network Connection, Create the VLAN
UPC - 606449052336
View all Netgear WFS709TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual Configure a VLAN for Network Connection Follow the instructions in this section only if you need to configure a trunk port between the WFS709TP and another Layer 2 switch (as in "Deployment Scenario #3" on page 2-4). This section shows how to use the browser interface for the following configurations: • Create a VLAN on the WFS709TP and assign it an IP address. • Assign to the VLAN the port or ports that you will use to connect the WFS709TP to the network. (For example, the uplink ports that you connect to a router are usually Gigabit ports.) • Configure the ports as trunk ports. • Configure a default gateway for the WFS709TP. Note: In the browser interface configuration pages, clicking the Apply button saves configuration changes so they are retained after the WFS709TP is rebooted. Create the VLAN The following configurations create VLAN 5 and assign it the IP address 10.3.22.20/24. 1. Navigate to the Configuration > Basic > Network >VLAN page. 2. Click Add to create a new VLAN. 3. On the Add New VLAN screen (Figure 2-7), enter 5 for the VLAN ID and click Apply. Figure 2-7 2-10 Deploying a Basic WFS709TP System v1.0, June 2007