Netgear WFS709TP WFS709TP Setup Manual - Page 166
SNMP for Access Points, Table 13-2. SNMPv3 User Details continued
UPC - 606449052336
View all Netgear WFS709TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 166 highlights
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual Table 13-2. SNMPv3 User Details (continued) Field Privacy protocol Privacy protocol password Description Expected/Recommended Value An indication of whether messages sent on behalf of this user can be protected from disclosure, and if so, the type of privacy protocol being used. This takes the value DES (CBC-DES Symmetric Encryption Protocol). If messages sent on behalf of this user can be encrypted/decrypted, the (private) privacy key for use with the privacy protocol. String password for DES. SNMP for Access Points Access points also support SNMP. The administrator can configure all or some of the APs to access data using SNMP as well as receive traps from the APs. The APs can be acting as Air Monitors (AMs) when they are used to access information about the wireless network using SNMP. The SNMP configuration for the APs can be done at a global level (thereby being applicable for all the APs in the network), or for a particular set of APs by using the AP location codes. Note: The configuration for access points is always done on the master WFS709TP only. To configure SNMP parameters for access points in the network at a global level: 13-4 v1.0, June 2007 Configuring Management Utilities