Nikon B0012OGF6Q D60 User's Manual - Page 29

Charging and Inserting the Battery 1.4 Charging is complete when the CHARGE lamp stops blinking. Remove the battery from the charger and unplug the charger. CHARGE lamp EN-EL9mAh 7.4V 1E0N0-0ELm9Ah 2 Insert the battery. 2.1 After confirming that the power switch is in the off position, open the battery chamber cover. 2.2 Insert a fully charged battery as shown at right. Close the battery chamber cover. Be sure that the battery contacts are facing down. 2 1 First Steps s B Removing the Battery Turn the camera off and confirm that the memory card access lamp is off before removing the battery. B The Battery and Charger • Read and follow the warnings and cautions on pages ii-iii and 164-166 of this manual, together with any warnings and instructions provided by the battery manufacturer. • Do not use the battery at ambient temperatures below 0 °C (32 °F) or above 40 °C (104 °F). During charging, the temperature should be in the vicinity of 5-35 °C (41-95 °F). For best results, charge the battery at temperatures above 20 °C (68 °F). Battery capacity may drop if the battery is charged or used at lower temperatures. • The battery may be hot immediately after use. If so, wait for the battery to cool down before charging. • Replace the supplied terminal cover after removing the battery from the camera or the quick charger to avoid shorting the battery. • Unplug the quick charger when it is not in use. 17