Oki C7200 Service Manual - Page 232
U: Upper-Heater Temperature Measurement [Set Value] in units of °C
View all Oki C7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
l A value in the shaded section is initial. The set values are applicable only to this test mode (No writing into EEPROM is performed.) l When the (3) key is pressed, with "PRINT EXECUTE" on the lower display after step 2, the test printing is executed using the values designated in steps 2 and 3. Pressing the (7) key suspends the test printing. l The following messages are showing at warm-up and during printing. P: Number of Sheets Printed for Test (in prints) U: Upper-Heater Temperature Measurement [Set Value] (in units of °C) L: Lower-Heater Temperature Measurement [Set Value] (in units of °C) T: Environmental Temperature Measurement (in units of °C) H: Environmental Humidity Measurement (in units of %) l The display is changed at the press of the 3 33 33 key. YTR, MTR, CTR and KTR mean the transfer voltage settings for colors (in KV). l The display is changed at the press of the 3 33 33 key. YR, MR, CR and KR are the transfer voltage measurements for transfer roller colors (in KV). 4. While "PRINT EXECUTE" is indicated in the lower display after the Item 2 procedure, press Key (3) to start test printing with the values set in Item 2 and 3 procedures.