Oki C7200 Service Manual - Page 391
Running Short
View all Oki C7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 391 highlights
410: Yellow 411: Magenta 412: Cyan 413: Black Remove Printed Papers 480: Stacker Full Load *** Papers 490: No paper in the MP Tray (***=A4,B5 etc) Load *** Papers 491 ~ 495: NO paper in the Tray * (***=A4, B5 etc) Replace Belt the four colors is running short. The stacker for ejected papers is full. The specified cause has no paper or is removed. Or, the cassette being used for printing has no more paper. No paper in the Cassette 1, 2, 3, 4 or 5 detected. The belt counter has reached the life value. Replace Fuser The fuser counter has reached the life value. Job Offset Home Error Running Short of Paper in Tray * The Job offset assy does not operate or cannot detect the home position. Running short of paper detected Disc Operation HDD can not be Error written. almost empty? No 2) Does the Toner sensor of the specified cartridge operate normally? 1) Is the stacker full? Yes 2) Does the Stacker full sensor operate No normally? 1) No paper in MT? Yes 2) Does the Paper out sensor operate No normally? 1) No paper in the specified cassette? Yes 2) Does the Paper out sensor operate No normally? 1) Is the error message displayed? Yes 2) Does the error occur soon after Belt No unit replacement? 1) Is the error message displayed? Yes 2) Does the error occur soon after No Fuser unit replacement? Does the Job offset assy operate Yes normally? No Does only small amount of papers Yes (approx. 30 sheets or less) remain? No Is the operating procedure correct? No Yes toner kit. Replace the Toner sensor for the specified color. Remove papers from the stacker. Replace the Stacker full sensor. Load papers in MT. Replace the Paper out sensor. Load papers in the specified cassette. Replace the Paper out sensor of the specified cassette. Check the belt life. Replace the Belt unit immediately or at the next maintenance. Check the fuser life. Replace the Fuser unit immediately or at the next maintenance. Replace the job offset sensor. Replace the Job offset motor or Engine board. Load papers. Check the Paper near end sensor. Confirm the procedure in the manual. Replace the HDD as it is broken. Copyright 1999, Okidata, Division of OKI America, Inc. All rights reserved.