Onkyo TX SR501 Owner Manual - Page 4

Precautions, Supplied Accessories, Features - control

Page 4 highlights

Precautions-Continued 1. Recording Copyright-Unless it's for personal use only, recording copyrighted material is illegal without the permission of the copyright holder. 2. AC Fuse-The AC fuse inside the TX-SR501/TX-SR501E is not user-serviceable. If you cannot turn on the TX-SR501/ TX-SR501E, contact your Onkyo dealer. 3. Care-Occasionally you should dust the TX-SR501/ TX-SR501E all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild detergent and water. Dry the TX-SR501/TX-SR501E immediately afterwards with a clean cloth. Don't use abrasive cloths, thinners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel lettering. 4. Power WARNING BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY. AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the voltage requirements printed on the TX-SR501/TX-SR501E's rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz). Supplied Accessories The Worldwide model has a voltage selector for compatibility with power systems around the world. Before you plug in this model, make sure that the voltage selector is set to the correct voltage for your area. Setting the [STANDBY/ON] switch to STANDBY does not fully shutdown the TX-SR501/TX-SR501E. If you do not intend to use the TX-SR501/TX-SR501E for an extended period, remove the power cord from the AC outlet. Memory backup The TX-SR501/TX-SR501E uses a battery-less memory backup system in order to retain radio presets and other settings when it's unplugged or in the case of a power failure. Although no batteries are required, the TX-SR501/TX-SR501E must be plugged into an AC outlet in order to charge the backup system. (On non-North American models, the TX-SR501/ TX-SR501E's POWER switch must be set to ON in order to charge the backup system.) Once it has been charged, the TX-SR501/TX-SR501E will retain the settings for several weeks, although this depends on the environment and will be shorter in humid climates. Make sure you have the following accessories: AM loop antenna Indoor FM antenna (connector type varies from country to country) Power-plug adapter Only supplied in certain countries. Use this adapter if your AC outlet does not match with the plug on the TX-SR501/ TX-SR501E's power cord. (Adapter varies from country to country.) Front Left Front Left SP-B / Zone 2 Left SP-B / Zone 2 Left Front Right Front Right SP-B / Zone 2 Right SP-B / Zone 2 Right Surround Left Surround Left Surround Right Surround Right Center Center Surround Back Left Surround Back Left Zone 2 Left Zone 2 Left Surround Back Right Surround Back Right Zone 2 Right Zone 2 Right Front Left Front Left SP-B / Zone 2 Left SP-B / Zone 2 Left Front Right Front Right SP-B / Zone 2 Right SP-B / Zone 2 Right Surround Left Surround Left Surround Right Surround Right Center Center Surround Back Left Surround Back Left Zone 2 Left Zone 2 Left Surround Back Right Surround Back Right Zone 2 Right Zone 2 Right 1 2 3 Speaker Cable Not supplied with North American and European models. Remote controller & two batteries (AA/R6) Speaker cable labels 75/300-ohm antenna adapter * In catalogs and on packaging, the letter added to the end of the product name indicates the color of the TX-SR501/TX-SR501E. Specifications and operation are the same regardless of color. Features Amp • 6-channel amplifier • 65 watts per channel into 8 ohms, 20 Hz-20 kHz with less than 0.08% total harmonic distortion • WRAT (Wide Range Amplifier Technology) • Optimum gain volume circuitry Audio/Video • Dolby*1 Digital EX and Dolby Pro Logic II • DTS, DTS-ES Matrix/Discrete 6.1, and DTS Neo:6 pro- cessing*2 • Cinema Filter function • Advanced 24-bit DSP chip (5 DSP soundfields) • Linear PCM 96 kHz/24-bit D/A converters on all channels • Adjustable crossover (60, 80, 100, 120, 150 Hz) • 2 component video inputs, 1 output • 4 S-Video inputs, 2 outputs • 3 assignable digital inputs (2 optical, 1 coaxial) • Subwoofer pre out • Color-coded multi-channel inputs • Color-coded speaker terminal posts (SPEAKERS B use push-type terminals) FM/AM Tuner • 30 FM/AM presets • FM auto tuning • RDS (Radio Data System) (Europe only) *1. Manufactured under license from Dolby Laboratories. "Dolby," "Pro Logic," Surround EX," and the double-D symbol are trademarks of Dolby Laboratories. *2. "DTS," "DTS-ES Extended Surround," and "Neo:6" are trademarks of Digital Theater Systems, Inc. 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

4
Precautions—
Continued
1.
Recording Copyright
—Unless it’s for personal use only,
recording copyrighted material is illegal without the permission
of the copyright holder.
2.
AC Fuse
—The AC fuse inside the TX-SR501/TX-SR501E is
not user-serviceable. If you cannot turn on the TX-SR501/
TX-SR501E, contact your Onkyo dealer.
3.
Care
—Occasionally you should dust the TX-SR501/
TX-SR501E all over with a soft cloth. For stubborn stains, use
a soft cloth dampened with a weak solution of mild detergent
and water. Dry the TX-SR501/TX-SR501E immediately after-
wards with a clean cloth. Don’t use abrasive cloths, thinners,
alcohol, or other chemical solvents, because they may damage
the finish or remove the panel lettering.
4.
Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.
AC outlet voltages vary from country to country. Make sure that the
voltage in your area meets the voltage requirements printed on the
TX-SR501/TX-SR501E’s rear panel (e.g., AC 230 V, 50 Hz or AC
120 V, 60 Hz).
The Worldwide model has a voltage selector for compatibility with
power systems around the world. Before you plug in this model,
make sure that the voltage selector is set to the correct voltage for
your area.
Setting the [STANDBY/ON] switch to STANDBY does not fully
shutdown the TX-SR501/TX-SR501E. If you do not intend to use
the TX-SR501/TX-SR501E for an extended period, remove the
power cord from the AC outlet.
Memory backup
The TX-SR501/TX-SR501E uses a battery-less memory backup
system in order to retain radio presets and other settings when it’s
unplugged or in the case of a power failure. Although no batteries
are required, the TX-SR501/TX-SR501E must be plugged into an
AC outlet in order to charge the backup system.
(On non-North American models, the TX-SR501/
TX-SR501E’s POWER switch must be set to ON in order to
charge the backup system.) Once it has been charged, the
TX-SR501/TX-SR501E will retain the settings for several
weeks, although this depends on the environment and will be
shorter in humid climates.
Supplied Accessories
Make sure you have the following accessories:
*
In catalogs and on packaging, the letter added to the end of the product name indicates the color of the TX-SR501/TX-SR501E. Specifications and operation
are the same regardless of color.
Features
Amp
6-channel amplifier
65 watts per channel into 8 ohms, 20 Hz–20 kHz with less
than 0.08% total harmonic distortion
WRAT (Wide Range Amplifier Technology)
Optimum gain volume circuitry
Audio/Video
• Dolby
*1
Digital EX and Dolby Pro Logic II
DTS, DTS-ES Matrix/Discrete 6.1, and DTS Neo:6 pro-
cessing
*2
Cinema Filter function
Advanced 24-bit DSP chip (5 DSP soundfields)
Linear PCM 96 kHz/24-bit D/A converters on all channels
Adjustable crossover (60, 80, 100, 120, 150 Hz)
2 component video inputs, 1 output
4 S-Video inputs, 2 outputs
3 assignable digital inputs (2 optical, 1 coaxial)
Subwoofer pre out
Color-coded multi-channel inputs
Color-coded speaker terminal posts (SPEAKERS B use
push-type terminals)
FM/AM Tuner
30 FM/AM presets
FM auto tuning
RDS (Radio Data System) (Europe only)
AM loop antenna
Indoor FM antenna
(connector type varies from
country to country)
Power-plug adapter
Only supplied in certain countries. Use
this adapter if your AC outlet does not
match with the plug on the TX-SR501/
TX-SR501E’s power cord. (Adapter var-
ies from country to country.)
Remote controller &
two batteries (AA/R6)
Speaker cable labels
75/300-ohm antenna
adapter
Not supplied with North American and
European models.
Front
Left
Front
Left
SP-B
/
Zone 2
Left
SP-B
/
Zone 2
Left
Surround
Right
Surround
Right
Surround Back
Right
Surround Back
Right
Zone 2
Right
Zone 2
Right
Front
Left
Front
Left
SP-B
/
Zone 2
Left
SP-B
/
Zone 2
Left
Front
Right
Front
Right
SP-B
/
Zone 2
Right
SP-B
/
Zone 2
Right
Front
Right
Front
Right
SP-B
/
Zone 2
Right
SP-B
/
Zone 2
Right
Surround
Right
Surround
Right
Center
Center
Center
Center
Surround
Left
Surround
Left
Surround
Left
Surround
Left
Surround Back
Right
Surround Back
Right
Zone 2
Right
Zone 2
Right
Surround Back
Left
Surround Back
Left
Zone 2
Left
Zone 2
Left
Surround Back
Left
Surround Back
Left
Zone 2
Left
Zone 2
Left
1
2
3
Speaker Cable
*1.
Manufactured under license from Dolby Laboratories. “Dolby,” “Pro Logic,” Surround EX,” and the double-D symbol are trademarks of Dolby Laborato-
ries.
*2.
“DTS,” “DTS-ES Extended Surround,” and “Neo:6” are trademarks of Digital Theater Systems, Inc.