Onkyo TX-SV444 Owner Manual - Page 12

Making antenna connections Outdoor antenna Indoor antenna 300 ohms ribbon wire Connecting the antenna cable to the 75/300 ohm antenna adaptor (Worldwide models) Connecting the 300 ohm ribbon wire: Loosen the screws and wrap the wire around these screws. Then tighten the screws with a screwdriver. Connecting the coaxial cable: 1 2 1. With your fingernail or a small screwdriver, press the stoppers outwards and remove the cover. - Slit B 15mm 2. Remove the transformer wire A from slit B and insert it into slit C. 3. Prepare the coaxial cable as shown in the diagram. Wire A Connect the 75/300 ohm antenna adaptor to the coaxial cable. Slit C (1) Insert the end of the cable. r:2) Clamp it in place with pliers. • This adaptor is included if your receiver is a worldwide model. Directional linkage type splitter To TX-SV444/TX-SE500 To TV (or VCR) 1 O Insert into the hole. 2 3 O Directional linkage Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each other. If you must use a common FM/ TV (or VCR) antenna, use a directional linkage type splitter. Assembling the AM loop antenna Assemble the loop antenna as shown in the illustration. Connesting the antenna cable I. Open the lever. 2. Insert the wire. 3. Close the lever. 12