Onkyo TX-SV444 Owner Manual - Page 2

Thank you for purchasing the Onkyo Audio Video Control Receiver. Please read this manual thoroughly before making connections and turning on the power. Followinng the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new Audio Video Control Receiver. Please retain this manual for future reference. Features • 70 Watts per channel into 8 ohms or 60 Watts to front three channels plus 20 Watts per channel for surround • 5-Channel discrete output stage drive for optimum AC-3/DVD performance (with external decoder) • All-channel low-impedance drive • Proprietary Lucasfilm Re-Equalization circuitry • Karaoke function with 2 mic inputs, voice cancel, pitch, echo and separate volume controls (TX-SE500) • Dolby- Pro Logic, Hall and Live surround IIII Intelligent Power Management (IPM) turn on whole system with TV • 3D-Bass for enhanced low frequencies • Dedicated line-level subwoofer output Manufactured under license from Dolby Laboratories Licensing Corporation. "Dolby'', the double-D symbol OD , and "Pro Logic"' are trademarks of Dolby Laboratories Licensing Corporation. ATTENTION FOR BRITISH MODEL Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. • IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Blue : Neutral Brown : Live As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. • IMPORTANT A 5 amp fuse is fi tted in this plug. Should the fuse need to he replaced, please ensure that the replacement fuse has a rating of 5 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE SHOULD BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY. THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET. 2 If in any doubt, please consult a qualified electrician. FOR U.S.A. MOD Note to CATV system installer: • This reminder is provided to call the CATV system installer's attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. FCC Information for User CAUTION: Changes or modifications not expressly approved by the manufacturer for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate ratio frequency energy and. if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment dose cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between other equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which other receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. FOR CANADIAN MODEL POUR LE MODELE CANADIEN • For models having a power cord with a polarized plug. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. • THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSION FROM DIGITAL APPARATUS SET OUT IN THE RADIO INTERFERENCE REGULATIONS OF THE CANADIAN DEPARTMENT OF COMMUNICATIONS. • Sur les modeles dont la fiche est polarisee. ATTENTION: POUR EVITER LES CHOCS ELEC- TRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU' AU FOND. • L'INTERFERENCE RADIO ELECTRIQUE GENEREE PAR CET APPAREIL NUMERIQUE DE TYPE B NE DEPASSE PAS LES LIMITES ENONCEES DANS LE REGLEMENT SUR LES PERTURBATIONS RADIO ELECTRIQUES, SECTION APPAREIL NUMERIQUE, DU MINISTERE DES COMMUNICATIONS. FOR EUROPEAN MODEL Declaration of Conformity We, ONKYO EUROPE ELECTRONICS GMBH INDUSTRIESTRASSE 18/20 821 10 GERMERING. GERMANY declare in own responsibility, that the ONKYO product described in this instruction manual is in compliance with the corresponding technical standards such as EN55013, EN55020, EN60555-2, -3 and EN60065 GERMERING,GERMANY H. YAMAZOE ONKYO EUROPE ELECTRONICS GMBH