Onkyo TX-SV444 Owner Manual - Page 18

Receiving stations D RECT TUNING -4 DOWN TUNING UP P. 1-9, 0/10 FM AM 2 . DOWN TUNING UP*. 1 zdIMINIIIIIIIIMININErA.SA , 1 FM AM 2 DIRECT TUNING 3 FM MUTE MODE 18 eez • O 0 C FM MUTE/MODE FM AM SPEAKERS A I /I I II SPEAKERS A II 11/I I II I SPEAKERS A VIDEO I /I I II FM MUTE 0.TUNED ON STEREO I _I I_ _I I I II I MH, SPEAKERS A SPEAKERS A I_ _I /I I II I SPEAKERS A VIDEO 121 FM MU, ON I I' /I I II MHz SPEAKERS A VIDEO 1I// I II FM MUTE ► TUNED ON STEREO I1 1 I I I I I. I SPEAKERS A VIDEO FM MUTE OFF I_ 1`/I I I I_ _I IT-I I I I I I. I MHz Manual tuning 1. Press the FM or AM button. 2. Use the TUNING UP/DOWN buttons to change the frequency. UP „ the frequency increases. DOWN ... the frequency decreases. • The frequency is changed in 100kHz (or 50kHz) steps in FM and 10kHz (or 9kHz) in AM when the TUNING UP/ DOWN button is pressed in single steps. • In FM, if this button is held continuously for more than 0.5 seconds, the frequencies are scanned automatically (FM auto tuning mode). When a broadcast is received, scanning stops. Direct tuning 1. Press the FM or AM button. 2. Press the DIRECT TUNING button. The "_ _" will flash 16 seconds in the frequency display. 3. Enter the frequency using the number buttons while the cursor is flashing. Example: 88. 10MHz 50kHz step area, 8 8 1 -5 01 i 0 l00kHz step area. 8 -s 8 I Use the 0/10 number button to enter a 0. • Out-of-range frequencies will be ignored. • When receiving AM broadcasts with a 10kHz steps, entering a number for the I 0kHz digit will set the IkHz digit to 0. Receiving RDS (TX-SV444 European model only) When an RDS (Radio Data System) station broadcasting PS (Program Service Name) information is received, the RDS indicator lights up and name of the station is displayed. • RDS reception is only available on the TX-SV444 European model, and only in areas where RDS broadcasts are available. Listening to a stereo radio stations (FM mode) If you tune in a stereo FM station, the STEREO indicator will be illuminated if the signal is sufficiently strong. If the signal is weak, it may be impossible to tune in to your desired station. In this case, tune in as follows. Press the FM MUTE/MODE button and FM MUTE OFF indicator lights. At this time, the station will be in mono and interstation noise will be heard. Select a station you want listen to.