Onkyo TX-SV444 Owner Manual - Page 19

Using preset stations GROUP 1-9, 0/10 . 1.11R.FR 2 MEMORY ± 3 GROUP I I) 0'10 0, 10 C GROUP O it MEMORY SCAN CLEAR SPEAKERS A VIDEO I I1 /I I II FM MUTE . TUNED 4 GROUP ON STEREO MEMORY A I_ _I 1. Li MHz CH SPEAKERS A VIDEO E FM MUTE .TUNED 4 GROUP ON STEREO MEMORY B /I I _I I I I 1. I MHz CH SPEAKERS A VIDEO 121 FM MUTE .TUNED 4 ON STEREO I 1, 4 I II LI I I I I _• I MHz GROUP GROUP 2-b SCAN GROUP A -4. PRESET it 4, Programming radio stations 1. Select the frequency that you want to store in the memory. (See Receiving stations on page 18.) 2. Press the MEMORY button. The MEMORY indicator will light for 8 seconds. 3. While the MEMORY indicator lights, press the GROUP button to choose the desired group. The group shown on the display changes in the following order each time the button is pressed: A -> B C A. 4. Select the desired memory number using the number buttons. Use the 0/10 number button to enter a 10. • Since ten AM or FM stations can be stored in each group (A, B or C), a total of 30 stations can be stored in the memory. Recalling preset stations 1. Press the GROUP button to select the desired group. 2-a. Input the memory number you wish to receive by using the number buttons. 2-b. Press the SCAN button. Each station stored in the group chosen in step 1 will be received for 5 seconds (for each station). When the station that you want is found, press the SCAN button again and scanning will stop. Use Remote controller Press the GROUP button and choose the group. Press the PRESET (-4 or lo-) button. CLEAR -- MEMORY FMMUTE1MODE II IJ Cancelling preset stations SPEAKERS A VIDEO E FM MUTE .TUNED/ ON STEREO 11/I 1 I1 I_I I_I I I I / I. MHz GROUP CH 1. Select the station as explained in the previous section. 2. Press the FM MUTE/MODE button while holding down the MEMORY button. "- -" will be shown on the channel display. • Once the preset station has been can- celled, the memory location can be used to store another station. 19