Panasonic PVDM2093 PVDM2093 User Guide - Page 59

*Important: If a remote control button does not work when pressed, press the TV/VCR , DVD button on the remote and try the button again. AUDIO OUTPUT Select the digital output to be output from the optical digital audio output connector of the unit. 1 Do steps 1 and 2 on page 58. 2 DVD MAIN MENU DISC LANGUAGES AUDIO OUTPUT ST I L L MODE : AUTO TV MODE : 4:3 Pan & Scan SELECT SET END : : SET : ACTION 1) Press to select "AUDIO OUTPUT." 2) Press SET to display screen. 3 AUDIO OUTPUT LPCM(DVD) Dolby Digital dts DRC : OFF : Bitstream : Bitstream : OFF SELECT SET END : : SET : ACTION 1) Press to select an item. 2) Press SET repeatedly for output. (See below.) ■ "LPCM (DVD)" selections OFF: Linear PCM of less than 48 kHz/16 bit is output. When playing DVDs recorded in linear PCM of over 48 kHz/20 bit, no digital audio is output. (Factory preset) PCM: When playing DVDs recorded in linear PCM of 48 kHz/20 bit/24 bit or more, digital audio converted to 44.1 kHz/16 bit or 48 kHz/16 bit is output. (Digital output of PCM audio is restricted to48 kHz/16 bit or below for copyright protection.) ■ "Dolby Digital" selections Bitstream: Dolby Digital bitstream (1ch-5.1ch) is output. (Factory preset) PCM: When you have connected a amplifier that doesn't have a built-in Dolby Digital decoder. ■ "dts" selections Bitstream: dts bitstream is output. (Factory preset) PCM: When you have connected a amplifier that doesn't have a built-in dts decoder. ■ "DRC (Dynamic Range Compression)" selections OFF: Normal audio range is selected. (Factory preset) ON: For dynamic sound even at low volume, this is useful for late-night listening. [Dolby Digital DVDs only]. 4 Press ACTION to redisplay DVD MAIN MENU and go to step 2 to setup another item. Or, press ACTION three times to exit. ACTION SELECT SET Type of amplifier to be connected Recommended setting LPCM (DVD) Dolby Digital dts No amplifier is connected AV amplifier without Dolby Digital/dts decoder PCM PCM*1 PCM*1 AV amplifier including Dolby Digital decoder PCM Bitstream PCM AV amplifier including Dolby Digital/dts decoder PCM Bitstream Bitstream*2 • Make settings according to amplifier connected to optical audio output as shown in above table. *1 When connecting an amplifier (with an optical digital input connector) which does not contain the Dolby Digital or dts decoder, be sure to select "PCM." If "Bitstream" is selected, starting DVD play may cause such a high level of noise as to be harmful to your ears and damage the speakers. *2 When a dts decoder is connected, please select "Bitstream" in "dts." If "PCM" is selected, there will be stereo sound. Advanced Operation 59