Panasonic SDC615 AJSDC615 User Guide - Page 32
Setting the time data
UPC - 791871302699
View all Panasonic SDC615 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Chapter 4 Adjustments and settings for recording Audio level meter in display window NDF SLAVE HOLD W GPS CTL VTCG TIME DATE P-iREC OVER 0 10 h Y minM TAPE E BATT E s D frm 20 B 30 F 40 OO 1 2 -dB Audio level meter display inside viewfinder F:1---- ∫ R:2---- ∫---+ For the audio levels to be adjusted by one person only, it is recommended that the F.AUDIO LEVEL controls be used. Select in advance the audio channels whose levels are to be adjusted, and while monitoring the level meter on the viewfinder screen, adjust the F.AUDIO LEVEL controls in such a way that the input will not be too high. 4-5 Setting the time data The time code setting range extends from 00:00:00:00 to 23:59:59:29. 4-5-1 Setting the user bits Memos and other information with up to 8 digits (dates, times) in hexadecimal notation can be recorded on the sub code track by setting the user bits. DISPLAY switch Display window 1 Set the DISPLAY switch to UB. 2 Set the TCG switch to SET. 3 Set the user bits using the SHIFT button, UP (+) button and DOWN (-) button. SHIFT button: This is used to cause the digit that is to be set to flash. Each time it is pressed, the flashing digit moves to the right. UP (+) button: This increments the numerical value of the flashing digit by 1. DOWN (-) button: This decrements the numerical value of the flashing digit by 1. 4 Set the TCG switch to F-RUN or R-RUN. 5 Open the screen from the VTR MENU page and select USER as the UB MODE item setting by performing menu operations. User bit memory function The user bit settings (except for the actual time) are automatically saved in the memory and retained even after the power is turned off. Tape continuity with the user bits Selecting REGEN for the UB MODE item on the screen by performing menu operations will call up the user bits recorded on the tape, making it possible to continue recording from that value. However, it is not possible to record the contents that were set. The time code/user bits are also recorded in the VIDEO AUX area of the unit's memory. The time code (VITC) is the same value as the sub code area's time code (LTC). Special information such as the camera's frame rate is recorded in the user bits (VITC's user bits). VITC's user bits ¢¢:0F:60:0¢ Fixed value Checking information for the 6 digits at right. Tape management information ≥ Renew frame flag ≥ REC START/STOP mark Camera shooting mode 600: 60i TCG switch DOWN (-) button UP (+) button HOLD switch 32