Panasonic SDC615 AJSDC615 User Guide - Page 89

Chapter 7 Menu description tables 7-3-12 CAMERA SETTINGS Item/ Data storage Variable range DETAIL ON S C U F E OFF 2D LPF ON S C U F E OFF HIGH COLOR ON OFF SCU F E GAMMA ON S C U F E OFF TEST SAW ON S C U F E OFF FLARE ON S C U F E OFF H-F COMPE. ON S C U F E OFF Remarks For selecting ON or OFF for DTL (H, V). For selecting ON or OFF for the 2dimensional LPF that reduces cross color. For selecting ON or OFF for the mode in which the dynamic range of the colors is expanded. For selecting ON or OFF for the gamma circuit. For selecting ON or OFF for the test signals. For selecting ON or OFF for the flare compensation. For selecting ON or OFF for the mode in which the wide-band DTL is increased. Video level 109% Zebra pattern display ZEBRA 2 ON OFF SPOT ZEBRA 2 DETECT ZEBRA 1 DETECT 0% 7-4 VF 7-4-1 VF DISPLAYS Item/ Data storage Variable range Remarks DISP CONDITION NORMAL HOLD CU F E DISP MODE 1 2 3 CU F E VF OUT Y NAM R G B CU F E VF DTL 0 : 3 : CU F E5 ZEBRA1 DETECT 0% : 70% : C U F E 109% ZEBRA2 DETECT 0% : 85% : C U F E 109% ZEBRA2 ON SPOT C U F E OFF LOW LIGHT LVL OFF 10% 15% 20% 25% 30% C U F E 35% ECU MENU DISP. ON OFF CU F E 50M INDICATOR ON SDC905 OFF NORMAL: The statuses are displayed at all times. HOLD: The statuses are displayed only when the MODE CHECK switch is pressed. For performing the DISP MODE setting. This item is used to select the camera's warning or message displays. For details, refer to "4-7-4 Display modes and setting changes/ adjustment result messages." For selecting the VF output. Y: Luminance signal NAM: The signal with the highest level among the R, G and B signals is output. R: R channel signal 7 G: G channel signal B: B channel signal For performing the VF DTL selection. This item is used to further emphasize the DTL of the VF signals. If 0 is set, the DTL will be the same as that of the main line signals. For setting the ZEBRA1 detection level (IRE level). For setting the ZEBRA2 detection level (IRE level). For selecting ON or OFF for ZEBRA2 or selecting SPOT. For setting how much lower the camera's input light quantity should be in order for "LOW LIGHT" to be displayed. For selecting ON or OFF for displaying the MENU on the viewfinder when the ECU is connected. For selecting ON or OFF for the displays during 50M recording. CU F E MARKER/ 50% CHAR LVL 60% 70% 80% 90% C U F E 100% For setting the brightness of the markers and characters displayed in the viewfinder. The underlining in the variable range column indicates the setting in the preset mode. 89