Pioneer AVICN5 Owner's Manual - Page 133
Adjusting loudness, Using subwoofer output, Using non fading output
UPC - 012562890166
View all Pioneer AVICN5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
Customizing the AV Source Setting Chapter 09 Customizing the AV Source Setting Setting a stage that fits your image 1 Touch [Staging] in Sound menu. 2 Touch the desired stage setting. p The [Living Room] setting that emphasizes midrange sound hardly has any effect near the maximum volume level. p When you set staging other than [Off], the high pass filter (HPF) setting turns [Off]. = For details, refer to Using the high pass filter on the next page. Adjusting a position effect You can select a listener position that you want to make as the center of sound effects. 1 Touch [Staging] in Sound menu. 2 Touch [Position]. 3 Touch the desired position. Adjusting loudness Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Touch [Loudness] in Sound menu. 2 Touch [On] to turn loudness on. To turn loudness off, touch [Off]. 3 Touch c or d to select a desired level. Each time you touch c or d selects level in the following order: Low - Mid - High Using subwoofer output This navigation system is equipped with a subwoofer output which can be turned on or off. p When the subwoofer output is on, you can adjust the cut-off frequency, the output level and the phase of the subwoofer. 1 Touch [Sub Woofer] in Sound menu. When [Preout] (the subwoofer controller setting in Initial menu) is [Sub. W], you can select [Sub Woofer]. = Refer to Setting the rear output and subwoofer controller on page 137. 2 Touch [On] to turn subwoofer output on. To turn subwoofer output off, touch [Off]. 3 Touch [Reverse] or [Normal] to select the phase of subwoofer output. 4 Touch [+] or [-] to adjust the output level of the subwoofer. +6 to -6 is displayed as the level is increased or decreased. 5 Touch c or d to select cut-off frequency. Each time you touch c or d selects cut-off frequencies in the following order: 50 - 80 - 125 (Hz) Only frequencies lower than those in the selected range are output from the subwoofer. Using non fading output When the non fading output setting is on, the audio signal does not pass through navigation system's low pass filter (for the subwoofer), but is output through the RCA output. 1 Touch [Non Fading] in Sound menu. Only when [Preout] (the subwoofer controller setting in Initial menu) is [Full], you can select [Non Fading]. = Refer to Setting the rear output and subwoofer controller on page 137. 2 Touch [On] to turn non fading output on. To turn non fading output off, touch [Off]. 3 Touch [+] or [-] to adjust the output level of the non fading. +6 to -6 is displayed as the level is increased or decreased. En 133