Pioneer AVICN5 Owner's Manual - Page 145
Appendix - wires
UPC - 012562890166
View all Pioneer AVICN5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Appendix Appendix Appendix Something covers the GPS antenna. Do not cover the GPS antenna with spray You cannot position your vehicle paint or vehicle wax, because this may block on the map or the positioning the reception of GPS signals. Snow buildup error is large. can also degrade the signals. Signals from the vehicle's speed Check that the cables are properly connected. pulse are not being picked up prop- If necessary, consult the dealer that installed erly. the system. The navigation system may not be mounted securely in your vehicle. Check that the navigation system is securely mounted and, if necessary, consult the dealer that installed the system. Your vehicle is operating in Simple hybrid mode. Connect the speed signal input (pink lead wire) of the power cable correctly, and reset the 3D Hybrid Sensor memory ([Learning Status]). The navigation system is installed with an extreme angle exceeding the limitation of the installation angle. Confirm the installation angle. (The navigation system must be installed within the allowed installation angle. For details, refer to "Installation Manual".) Indication of the position of your vehicle is misaligned after a U-turn or reversing. Check whether or not the reverse gear signal input lead (violet) is connected properly. (The navigation system works properly without the lead connected, but positioning accuracy will be adversely affected.) The map continually reorients it- The traveling direction is set to self. Heading up. Touch on the screen and change the map display. Tracking marks are not displayed. [Tracking Display] is turned off. Check [Tracking Display] settings and make sure [Always] or [This Trip] is selected. (Page 83) The daylight display is used even when the vehicle lights are on. [Daytime] is set to [Day/Night Display]. The orange/white lead is not connected. Check [Day/Night Display] setting and make sure [Nighttime] is selected. (Page 83) Check the connection. The system will not switch on or Installation or connection has been Check with your dealer. will not operate. carried out incorrectly. The display is very dim. The vehicle's light is turned ON, and Read about [Day/Night Display] setting and, [Nighttime] is selected on [Day/ if desired, select [Daytime]. (Page 83) Night Display]. The vehicle cabin temperature is ex- A Liquid Crystal Display (LCD) is used, and tremely low. such displays tend to darken when cold. Wait for the vehicle to warm up. Picture quality adjustment of the display is not correct. Refer to "Page 142" to adjust the picture quality. No sounds are heard. The volume level will not rise. The volume level is low. The attenuator or mute is on. Adjust the volume level. Turn the attenuator or mute off. The speaker lead is disconnected. Check the connection. Adjusting the volume of naviga- You cannot adjust them with VOtion guidance and beeps is not LUME knob. possible. Turn the volume up or down according to [Volume] in [Settings] menu. (Page 80) En 145