Ricoh 8100DN Hardware Guide - Page 41
Store the controller board 1 into the printer while gently pressing the, to remove the default module
UPC - 026649025952
View all Ricoh 8100DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Installing Options I When replacing the default SDRAM module, press down the levers on both sides ( ) to remove the default module ( ). 2 AQV763S Install a new SDRAM module. To increase memory capacity to the maximum of 512 MB, remove the default SDRAM module, and then install two 256 MB SDRAM modules. J Store the controller board (1) into the printer while gently pressing the cover (2). AQV502S Push in the controller board firmly to align the rails in the printer's compartment. K Fasten all the screws which you removed in step C. AQV503S The printer may malfunction if the controller board is not properly installed. 30
Installing Options
30
2
I
When replacing the default SDRAM module, press down the levers on
both sides (
) to remove the default module (
).
Install a new SDRAM module.
To increase memory capacity to the maximum of 512 MB, remove the default
SDRAM module, and then install two 256 MB SDRAM modules.
J
Store the controller board (1) into the printer while gently pressing the
cover (2).
Push in the controller board firmly to align the rails in the printer's compart-
ment.
K
Fasten all the screws which you removed in step
C
.
The printer may malfunction if the controller board is not properly installed.
AQV763S
AQV502S
AQV503S