Schwinn 490 Elliptical Service Manual - Page 31
from the Inner Pivot Shroud.
 |
View all Schwinn 490 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
5. Gently compress the sides of the Pivot Cap to release it from the Inner Pivot Shroud. 6. Using a #2 Phillips screwdriver, remove the 2 screws (indicated by ovals) from the Inner Pivot Shroud. 7. Tie a 60 cm (24 inch) long piece of wire or string to the end of the Cable. This wire or string will be used to pull the new cable through and out of the Lower Handlebar. Pivot Cap Sensor Hub to Upper Handlebar Buttons Cable Inner Pivot Shroud Lower Handlebar 8. Using a 6mm hex wrench, remove the hardware (indicated by ovals) that attaches the Pedals and remove them. Pivot Pin Note: To assist with re-assembly, notice that the Pivot Pin is flush with the outside of the Lower Handlebar. Pedal Pedal 31
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26 -
27 -
28 -
29 -
30 -
31 -
32 -
33 -
34 -
35 -
36 -
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52
-
53
-
54
-
55
-
56
-
57
-
58
-
59
-
60
-
61
-
62
-
63
-
64
-
65
-
66
-
67
-
68
-
69
-
70
-
71
-
72
-
73
-
74
-
75
-
76
-
77
-
78
-
79
-
80
-
81
-
82
-
83
-
84
-
85
-
86
 |
 |
31
Pivot Cap
Inner Pivot
Shroud
Lower Handlebar
Sensor Hub to
Upper Handle-
bar Buttons
Cable
5.
Gently compress the sides of the Pivot Cap to release it
from the Inner Pivot Shroud.
6.
Using a #2 Phillips screwdriver, remove the 2 screws
(indicated by ovals) from the Inner Pivot Shroud.
7.
Tie a 60 cm (24 inch) long piece of wire or string to the
end of the Cable. This wire or string will be used to pull the
new cable through and out of the Lower Handlebar.
8.
Using a 6mm hex wrench, remove the hardware
(indicated by ovals) that attaches the Pedals and remove
them.
Pedal
Pedal
Pivot Pin
Note:
To assist with re-assembly,
notice that the Pivot Pin is
flush with the outside of the
Lower Handlebar.