Schwinn 490 Elliptical Service Manual - Page 68
Using a 6mm hex wrench, remove the hardware
View all Schwinn 490 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
5. Using a 6mm hex wrench, remove the hardware (indicated by ovals) that attaches the Pedals and reXm2ove them. Pivot Pin Note: To assist with re-assembly, notice that the Pivot Pin is flush with the outside of the Lower Handlebar. There is also a Wave Washer on the post from the Pedal. Note: With the Pedal removed, do not fully rotate the Lower Handlebars or damage to the cables in the Handlebars will occur. 6. Using a 6mm hex wrench, remove the hardware (indicated by an oval) from the Legs and remove them. Note: To assist with re-assembly, notice there is a Wave Washer on the post from the Crank Arm. Pedal 6mm B Pedal X2 ** C X2 * Leg X2 6mm * Crank Arm Leg 68
68
5.
Using a 6mm hex wrench, remove the hardware
(indicated by ovals) that attaches the Pedals and remove
them.
There is also a Wave Washer on the post from the
Pedal.
Note:
With the Pedal removed, do not fully rotate the
Lower Handlebars or damage to the cables in the
Handlebars will occur.
6.
Using a 6mm hex wrench, remove the hardware
(indicated by an oval) from the Legs and remove them.
Note:
To assist with re-assembly, notice there is a Wave
Washer on the post from the Crank Arm.
Pedal
Pedal
Pivot Pin
Leg
Leg
Note:
To assist with re-assembly,
notice that the Pivot Pin is flush
with the outside of the Lower
Handlebar.
X2
*
Crank Arm