Schwinn 490 Elliptical Service Manual - Page 59
Electrical Wiring Route Detail, Servo Motor
View all Schwinn 490 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
5. Using a 3mm hex wrench, remove the hardware (indicated by ovals) from the old Servo Motor. 6. Using a 3mm hex wrench, attach the new Servo Motor to the Frame. Be sure thHatAtNheDSLEeBrvAoRM, LoEtFoTr Arm is in the range shown below before securing the Linkage Arm. ASSY, CABLE/PCBA, REMOTE BUTTON - INCLINE Servo Motor Arm UP 7.WCIRoEnAnSeSctYth- eINtCabLsINoEn the end of the Linkage Arm to the Brake Assembly. 8. Connect theDSOerWvoNMotor Cable Connectors. NOTICE: D o not pinch or cut the cables. CONSOLE MAST WIRE ASSY, CONSOLE TO M WIRE, CABLE ASSY, CONSOLE MAST LEFT ELECTRICAL WIRING ROUTE DETAIL - Servo Motor Speed Sensor Resistance Sensor CABLE ASSEMBLY, HUB to MAST HARNESS CABLE, SPEED SENSOR WIRE ASSY, SPLIT CBL RESISTANCE SENS, SPEED SENSOR, & SERVO SENSOR HUB HANDLE BAR BUTTON SERVO DC POWER 59 SENSOR HUB LIFT MOTOR CONTROL LIFT C