Schwinn 490 Elliptical Service Manual - Page 4

SPECIFICATIONS Power Requirements: 120V 220V Operational Voltage: 110-127V AC, 60Hz 220V - 240V AC, 50Hz Operating Current: 2A 2A Maximum User Weight: Total Surface Area (footprint) of equipment: Maximum Pedal Height - with full incline: Machine Weight: 150 kg (330 lb) 12,723 cm2 28.3 in ( 72 cm) approx. 84.8 kg (187 lb) 172.6 cm ( 68 in ) This product complies with the European Radio Equipment Directive 2014/53/EU DO NOT dispose of this product as refuse. This product is to be recycled. For proper disposal of this product, please follow the prescribed methods at an approved waste center. 86.2 cm ( 33.9 in ) 147.6 cm ( 58.1 in ) For safe operation, the location must be on a hard, level surface. Allow a minimum workout area of 82.1 in x 57.9 in (208.5 cm x 147.1 cm). Keep the workout area clear 0.6 m (24 in) along the side used to access the machine and to the rear of the machine. Be sure that the workout space you are utilizing has adequate height clearance, taking into consideration the height of the user and the 1.5 m maximum incline of the elliptical machine. (57.9 in) 0.6 m ( 24 in ) 2.1 m (82.1 in) 0.6 m ( 24 in ) FCC Compliance ! Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. The machine and power supply comply with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This machine and power supply have been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This product complies with the European Radio Equipment Directive 2014/53/EU 4