Schwinn 490 Elliptical Service Manual - Page 32
Cable, pull the cable down into the machine from
 |
View all Schwinn 490 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
9. Using a 6mm hex wrench, remove the hardware (indicated by oval) that secures the Lower Handlebar. Sensor Hub to Upper Handlebar Buttons Cable 10. Slide the Lower Handlebar outward only about 1 inch (2.5 cm) from the machine. 11. Push the Inner Pivot Shroud toward the machine, off of the Lower Handlebar. This will release the Cable from the clips on the Inner Pivot Shroud. 12. With the wire or string still attached to the end of the Cable, pull the cable down into the machine from the Handlebar. Be sure not to pull the end of the wire or string into the Lower Handlebar. Inner Pivot Shroud Inner Pivot Shroud Sensor Hub to Upper Handlebar Buttons Cable 32
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27 -
28 -
29 -
30 -
31 -
32 -
33 -
34 -
35 -
36 -
37 -
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52
-
53
-
54
-
55
-
56
-
57
-
58
-
59
-
60
-
61
-
62
-
63
-
64
-
65
-
66
-
67
-
68
-
69
-
70
-
71
-
72
-
73
-
74
-
75
-
76
-
77
-
78
-
79
-
80
-
81
-
82
-
83
-
84
-
85
-
86
 |
 |
32
Sensor Hub to
Upper Handle-
bar Buttons
Cable
Inner Pivot
Shroud
Inner Pivot
Shroud
10.
Slide the Lower Handlebar outward only about 1 inch
(2.5 cm) from the machine.
11.
Push the Inner Pivot Shroud toward the machine, off of
the Lower Handlebar. This will release the Cable from the
clips on the Inner Pivot Shroud.
12.
With the wire or string still attached to the end of the
Cable, pull the cable down into the machine from the
Handlebar. Be sure not to pull the end of the wire or string
into the Lower Handlebar.
9.
Using a 6mm hex wrench, remove the hardware
(indicated by oval) that secures the Lower Handlebar.
Sensor Hub to
Upper Handle-
bar Buttons
Cable