Schwinn 490 Elliptical Service Manual - Page 72
Fully remove the Lower Handlebar from the Pivot Rod.
View all Schwinn 490 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
15. Slide the Lower Handlebar outward only about 1 inch (2.5 cm) from the machine. 16. Push the Inner Pivot Shroud toward the machine, off of the Lower Handlebar. This will release the Cable from the clips on the Inner Pivot Shroud. 17. With the wire or string still attached to the end of the Cable, pull the Cable toward the machine out of the Lower Handlebar. Be sure not to pull the end of the wire or string into the Lower Handlebar. 18. Remove the wire or string from the Cable, and tie the wire or string off at both ends of the Lower Handlebar. This will be used to route the Cable back through the Lower Handlebar. 19. Fully remove the Lower Handlebar from the Pivot Rod. If replacing the Left Main Shroud, repeat the steps to remove the Left Lower Handlebar. Inner Pivot Shroud 72