Sharp GX20 Service Manual - Page 79
Camera Adjustment/Test
View all Sharp GX20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
CONFIDENTIAL Key "" Description Volume control. "" Volume control. "Centre" End Contents Turn up the volume by 1 level. During playback of ring tone: Ring tone is changed. During key touch tone output: Incoming audio volume is changed. Turn down the volume by 1 level. During playback of ring tone: Ring tone is changed. During key touch tone output: Incoming audio volume is changed. Shifting from this mode to the initial screen. 4. Press the key "Centre" to return to the initial screen with the display, "Diag Param Saving". 5. Press the "End/Power" key to finish operation. 2. Camera Adjustment/Test Serial Signal Format for Camera Adjustment/Test GX20 Item Dark current correction and white flaw check. Incoming Serial Signal Command n WHC Swwx (Including ini- yyyzaaa tialization) bbb Recommended value: 00840 12000 0000 Outgoing Serial Signal Response In the case of OK. AAAA, BBB AAAA: Number of white flaws BBB: Max. level In the case of NG. COUNT NG (More than 2000 white flaws) 000000: Insufficient light shielding Contents S: Mode (0 to 3) Recommended value: 0 ww: Dividing ratio (00 to 16) Recommended value: 08 x: Average number (0 to 4) Recommended value: 4 yyy: Thresholddetection frequency (000 to 255) Recommended value: 012 z: G Data mode (0 to 3) *1 Recommended value: 0 aaa: Stabilized frame number immediately after startup Recommended value: 000 bbb: Frame rate to be corrected Recommended value: 000 Test Method Refer to the "Adjustment procedures after replacement of parts" on pages 2 - 36 to 2 - 38. White flaw correction *1 Camera ON/ OFF WH (Including initialization) CAM None 6 5 4 3 2 1 0 Shutter ON/ SHT 2 OFF 1 0 Zoom ZOOM 2 ON/OFF 1 0 OK CAMn SHT n ZOOM n White flaw correction. ON (QQVGA Macro pre-flash [White])*3 ON (QQVGA full output [White])*2 ON (QQVGA Normal pre-flash [White]) *3 D'ont support ON (VGA) ON (QQVGA) OFF Shutter ON (Full output [White] 400 mS) *4 Shutter ON Shutter OFF ZOOM ON (4 x Zoom) ZOOM ON (2 x Zoom) ZOOM OFF *ZOOM only available for CAM, CAM4, or CAM5 Refer to the "Adjustment procedures after replacement of parts" on pages 2 - 36 to 2 - 38. Checking photography. To switch to the other mode, power off and then send the command again. Shutter ON/OFF operation. When SHT 1 or 2 is transmitted, the shutter turns ON; when SHT0 (to fix the screen) is transmitted, the shutter is released. Changing zoom. When ZOOM 1 is transmitted, the double size image is displayed; when ZOOM 2 is transmitted, the original state is returned. * 1: Be sure to check white flaw (WHC command) before performing white flaw correction (WH command). * 2: CAM5 Full output of flash is given 0.5 sec after the camera startup and then lights out. * 3: CAM4,6 Pre-flash 0.5 sec after the camera startup. * 4: SHT2 After full output, pre-flash also lights out. 2 - 73