Sony DSX-S210X Operating Instructions - Page 24
Searching a track by listening to track passages - ZAPPIN™
View all Sony DSX-S210X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Searching a track by listening to track passages - ZAPPIN™ While playing back short track passages in a USB device in sequence, you can search for a track you want to listen to. ZAPPIN mode is suitable for searching for a track in shuffle or shuffle repeat mode. 1 Press (ZAP/SHUF) during playback. After "ZAPPIN" appears in the display, playback starts from a passage of the next track. The passage is played for the set time, then a click sounds and the next passage starts. Track (ZAP/SHUF) pressed. The part of each track to playback in ZAPPIN mode. 2 Press the multi-way encoder or (ZAP/SHUF) when a track you want to listen is played back. The track that you select returns to normal play mode from the beginning. To search a track by ZAPPIN mode again, repeat steps 1 and 2. In the case of "SensMe™ channels" playback If the track being searched is transferred by "Content Transfer," the most melodic or rhythmical sections* of tracks are played. For details on the SensMe™ function, see page 15. * May not be detected correctly. Tips • You can select the playback time from about 6 seconds/15 seconds/30 seconds (page 28). You cannot select the passage of the track to playback. • Push the multi-way encoder left/right in ZAPPIN mode to skip a track. • Push the multi-way encoder up/down in ZAPPIN mode to skip album. 24 Sound Settings and Setup Menu Changing the sound settings Adjusting the sound characteristics 1 During reception/playback, press the multi-way encoder. 2 Rotate the multi-way encoder until the desired menu item appears, then press it. 3 Use the multi-way encoder to select the setting, then press it. 4 Press (BACK). The setting is complete and the display returns to normal reception/play mode. The following items can be set: The operation of the multi-way encoder will differ depending on the items. : Push the multi-way encoder up/down : Push the multi-way encoder left/right : Rotate the multi-way encoder EQ7 Preset (page 25) EQ7 Parametric Tune (page 25) Listening Position Front/Rear (page 25) Listening Position Subwoofer (page 26) Listening Position Custom Tune (page 26) Fader & Balance Front/Rear/Center ( ) Adjusts the relative level. Right/Left/Center ( ) Adjusts the sound balance. Subwoofer Tune & LPF Phase ( ) Selects the phase: "Normal," "Reverse." FREQ ( ) Selects the subwoofer cut-off frequency: "50Hz," "60Hz," "80Hz," "100Hz," "120Hz." Slope ( ) Selects the LPF slope: "1," "2," "3." Subwoofer Level ( ) Adjusts the subwoofer volume: "+10 dB" - "0 dB" - "-10 dB." ("- ∞" is displayed at the lowest setting.) HPF FREQ ( ) Selects the cut-off frequency: "off," "50Hz," "60Hz," "80Hz," "100Hz," "120Hz." Slope ( ) Select the HPF slope: "1," "2," "3." DM+ Advanced (page 26) Rear Bass Enhancer (page 27)