Sony DSX-S210X Operating Instructions - Page 31
Specifications, AUDIO POWER SPECIFICATIONS
View all Sony DSX-S210X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Specifications AUDIO POWER SPECIFICATIONS CEA2006 Standard Power Output: 17 Watts RMS 4 at 4 Ohms < 1% THD+N SN Ratio: 80 dBA (reference: 1 Watt into 4 Ohms) Tuner section FM Tuning range: 87.5 - 107.9 MHz Antenna (aerial) terminal: External antenna (aerial) connector Intermediate frequency: 150 kHz Usable sensitivity: 10 dBf Selectivity: 75 dB at 400 kHz Signal-to-noise ratio: 70 dB (mono) Separation: 40 dB at 1 kHz Frequency response: 20 - 15,000 Hz AM Tuning range: 530 - 1,710 kHz Antenna (aerial) terminal: External antenna (aerial) connector Intermediate frequency: 25 kHz Sensitivity: 26 µV USB Player section Interface: USB (Full-speed) Maximum current: 500 mA Power amplifier section Output: Speaker outputs Speaker impedance: 4 - 8 ohms Maximum power output: 52 W × 4 (at 4 ohms) General Outputs: Audio outputs terminal (front/rear) Subwoofer output terminal (mono) Power antenna (aerial) relay control terminal Power amplifier control terminal Inputs: Remote controller input terminal Antenna (aerial) input terminal Telephone ATT control terminal Illumination control terminal BUS control input terminal BUS audio input terminal USB signal input connector (internal/external) Power requirements: 12 V DC car battery (negative ground (earth)) Dimensions: Approx. 178 × 50 × 180 mm (7 1/8 × 2 × 7 1/8 in) (w/h/d) Mounting dimensions: Approx. 182 × 53 × 163 mm (7 1/4 × 2 1/8 × 6 1/2 in) (w/h/d) Mass: Approx. 1.1 kg (2 lb 7 oz) Supplied accessories: Card remote commander: RM-X172 USB connector for iPod XA-50IP Parts for installation and connections (1 set) Optional accessories/equipment: Source selector: XA-C40 USB connection cable for iPod: RC-100IP HD RadioTM tuner: XT-100HD Walkman adaptor XA-50WM Your dealer may not handle some of the above listed accessories. Please ask the dealer for detailed information. Design and specifications are subject to change without notice. System requirements for using SensMe™ Computer • CPU/RAM - IBM PC/AT compatible machine - CPU: Intel Pentium III Processor 450 MHz or higher - RAM: 256 MB or more (For Windows XP), 512 MB or more (For Windows Vista or later) • USB port OS Windows XP, Windows Vista, Windows 7 For details on compatible editions or Service Pack, visit the following support site: http://esupport.sony.com http://www.sony.com/mobileAV Monitor High color (16-bit) or more, 800 × 600 dots or more Other Internet connection Notes • The following system environments are not supported. - Non IBM PC type computers, such as Macintosh, etc. - Homemade computers - OS upgraded computers - Multi-display environment - Multi-boot environment - Virtual machine environment • Depending on the computer condition, operation may not be possible even with the recommended environment. 31