Sony VPL AW15 Operating Instructions - Page 52
On-screen display, Remote control, Others, Symptom, Cause and Remedy - replacement lamp
UPC - 027242703094
View all Sony VPL AW15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Symptom The picture is too dark. The picture is not clear. The picture flickers. Cause and Remedy c Adjust the contrast or brightness of the Picture properly. (1 page 41) menu c Adjust the focus using the focus ring. (1 page 24) c Condensation has accumulated on the lens. Leave the projector for about 2 hours with the power on. c Activate "APA", then adjust the current input signal. c Adjust "Phase" for "Adjust Signal" in the Screen menu properly. (1 page 45) On-screen display Symptom Cause and Remedy On-screen display does not c Set "Status" in the Setup menu to "On." (1 page 46) appear. c Check if the ?/1 (On/standby) indicator should light in green. The model name does not disappear from the screen. c The display mode of the projector may be set at the time of purchase. Consult with your local dealer or qualified Sony personnel. Remote control Symptom The remote control does not work. Cause and Remedy c Batteries could be weak. Replace them with new batteries. (1 page 11) c Insert the batteries with the correct polarities. (1 page 11) c If there is a fluorescent lamp near the remote control detector, the projector may work improperly or inadvertently. Others Symptom The fan is noisy. Cause and Remedy c Check the setting of "Cooling Setting" in the Setup menu. (1 page 46) c Make sure that the room temperature is not too high. The number of fan rotation increases to maintain the product reliability of the projector's components in a room, where the temperature is higher than normal. The fan noise becomes slightly louder. The approximate normal temperature is 25°C. 52