Sony VPL AW15 Operating Instructions - Page 54

Message Lists Warning messages Message Cause and Remedy High temp.! Lamp off in 1 min. c Turn off the power. c Check to ensure that nothing is blocking the ventilation holes. (1 page 13) Frequency is out of range! c Frequency is out of range. Input a signal that is within the acceptable frequency range of the projector. Please check Input-A Signal Sel. c Set "Input-A Signal Sel." in the Setup menu to "Computer" when an RGB signal is input from a computer. (1 page 47) Please replace the Lamp/ Filter. c It is time to replace the lamp. Replace the lamp. (1 page 55) c Also, replace the air filter too. Restart cleaning the Ventilation holes (intake). (1 page 55) If this message appears again after you replace the lamp and filter, the lamp replacement process is not complete. Check the lamp replacement process. (1 page 55) Note To clear this message, press any button either on the remote control or the control panel of the projector once. Please replace the filter. c It is time to replace the air filter. Replace the air filter. (1 page 58) Please replace the filter. Have you finished? Yes No c It is time to replace the air filter. Replace the air filter. (1 page 58) c If you replaced the air filter, select "Yes." If you did not replace the air filter, select "No." Projector temperature is high. Cooling Setting should be "High" if projector is being used at high altitude. c Check to ensure that the Ventilation holes on the unit are not covered. (1 page 13) c When using the projector at high altitude, set the Cooling Setting to "High". (1 page 46) Note When temperature inside the projector remains high, the Cooling Setting is switched to "High" in 1 minute, then the fan speed increases. Caution messages Message x Not applicable! Cause and Remedy c No signal is input in the selected input. Check connections. (1 page 17) c Press the appropriate button. c The operation to be activated by the button is currently prohibited. 54