Home » TEAC Manuals » DVD Drives » TEAC DW-224E-V » Manual Viewer

TEAC DW-224E-V Hardware Specification - Page 28

Command Set

Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

14.5 COMMAND SET 14.5.1 ATA COMMAND Refer to table 14.5.1-1. (Table 14.5.1-1) ATA COMMAND CODE 08 E5 90 E3 E1 00 A0 A1 EF E6 E2 E0 A2 COMMAND ATAPI SOFT RESET CHECK POWER MODE EXECUTE DRIVE DIAGNOSTIC IDLE IDLE IMMEDIATE NOP ATAPI PKT. ATAPI IDENTIFY DEVICE SET FEATURE SLEEP STANDBY STANDBY IMMEDIATE SERVICE - 26 -

Section	Page
1. SCOPE	3
2. OUTLINE	3
3. CONSTRUCTION	4
3.1 External Construction	4
3.2 Installation	6
4. DISC SPECIFICATION	7
4.1 Applicable Disc Format	7
4.2 Rotational Speed	7
4.3 Data Capacity	8
4.4 Write methods	8
4.5 Readable disc	8
4.6 Recordable Disc (Recording Speed)	8
5. PERFORMANCE	9
5.1 Operating Performance	9
5.2 Audio	9
5.3 Acoustic Noise	9
6. ENVIRONMENTAL CONDITIONS	10
7. RELIABILITY	11
8. SAFETY STANDARDS	11
9. FRONT INDICATOR	11
10. DRIVE CONFIGURATION	11
11. INTERFACE CONNECTOR	12
12. AUDIO INTERFACE	13
13. POWER INTERFACE	13
14. IDE HARDWARE INTERFACE	14
14.1 Outline	14
14.2 Electrical Characteristics	14
14.3 Input/Output Signals	15
14.4 Interface Timing	16
14.5 COMMAND SET	28
14.5.1 ATA COMMAND	28
14.5.2 ATAPI COMMAND	29
15. POWER MANAGEMENT SPECIFICATION	31
15.1 Power Management Modes	31
15.1.1 Transition in power management mode	31
15.2 Active Mode	32
15.3 Idle Mode	32
15.4 Standby Mode	33
15.5 Sleep Mode	33
15.5.1 Tray ejection/insertion in the sleep mode	33
16. OTHERS	33
16.1 Using the lens cleaner	33