Vtech Three Handset Connect to CELL™ Answering System with Caller ID Use - Page 11

Getting started Installation options Your telephone base is ready for tabletop use. I�f�y��o�u��w�a��n�t�t�o��m��o�u�n��t�y�o�u��r telephone on a wall, use the provided wall mount bracket to connect with a standard dual-stud telephone wall mounting plate. If you do not have this mounting plate, you can purchase one from many hardware or consumer electronics retailers. You may need a professional to install the mounting plate. Tabletop to wall mount installation 1. Plug one end of the telephone line cord into the TEL LINE jack on the bottom of the telephone base. Plug the small end of the telephone base power adapter into the POWER jack on the bottom of the telephone base. 2. Position the lower portion grooves on the telephone base to the lower portion tabs (marked B) on the wall mount bracket. Make sure the upper portion grooves of the telephone base are above the upper portion tabs (marked A) on the wall mount bracket. Push the telephone base down until it clicks securely in place. 3. Route the telephone line cord (or DSL filter) through the wall mount bracket hole and plug it into the telephone wall jack. Route the power cord out of the bottom of the telephone and plug it into an electrical outlet not controlled by a wall switch. 4. Align the holes on the bracket with the standard wall plate and slide the bracket down until it locks securely. Bundle the telephone line cord and power adapter cord neatly with twist ties. 1 2 3 4