Weider 9900i Uk Manual - Page 33

cables, you will need to remove the slack by tightening the cables. See MAINTENANCE

Get Weider 9900i PDF manuals and user guides View all Weider 9900i manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

61. Insert a Pulley (69) under the High Cable (44) in the location shown. 61 Attach the Pulley (69) inside the Top Frame (6) with an M10 x 65mm Bolt (75), two M10 Washers (88), two 12.7mm Spacers (73), and an M10 Locknut (74). 74 88 73 69 44 6 73 88 75 62. Attach the hook on the Burn Band (26) to the High or Low Anchor (C, D) on the Burn Cable 62 (45). 26 45 Hook C D 63. Make sure that all parts are properly tightened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 34. Before using the weight system, pull each cable a few times to make sure that the cables move smoothly around the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on page 38 for proper cable routing. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on page 39. 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
33
63. Make sure that all parts are properly tightened. The use of the remaining parts will be explained in
ADJUSTMENT, beginning on page 34.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
around the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is
used. See the CABLE DIAGRAM on page 38 for proper cable routing. If there is any slack in the
cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on page 39.
61
61. Insert a Pulley (69) under the High Cable (44) in
the location shown.
Attach the Pulley (69) inside the Top Frame (6)
with an M10 x 65mm Bolt (75), two M10
Washers (88), two 12.7mm Spacers (73), and
an M10 Locknut (74).
69
44
73
88
75
73
88
74
6
62
62. Attach the hook on the Burn Band (26) to the
High or Low Anchor (C, D) on the Burn Cable
(45).
26
45
Hook
C
D