Weider 9900i Uk Manual - Page 39
Maintenance
View all Weider 9900i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
MAINTENANCE Make sure that all parts are properly tightened each time the weight system is used. Replace any worn parts immediately. To clean the weight system, use a damp cloth and a mild, non-abrasive detergent; do not use solvents to clean the weight system. TIGHTENING THE CABLES Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. To tighten the cables, first insert the weight pin into the middle of the weight stack. Slack can be removed from the cables several ways: Remove an M10 Locknut (74) and an M10 x 43mm Bolt (65) from two Pulley Plates (70) and a Pulley (69). Reattach the Pulley (69) to a hole closer to the center of the Pulley Plates (70). Make sure that the Cable (43, 44) and Pulleys move smoothly. 44 74 70 65 69 43 Loosen the Nut (A) on the High Cable (44). Tighten the High Cable (44) into the Weight Selector (32) until the slack is removed from the High Cable. Then, retighten the Nut (A) against the Burn Cable (45). 44 A 45 32 Do not overtighten the cables. If the cables are overtightened, the top weight will be lifted off the weight stack. If a cable tends to slip off the pulleys often, it may have become twisted. Remove the cable and reinstall it. If the cables need to be replaced, see the back cover of this manual. 39