Whirlpool GBS277PDB Technical Guide - Page 15

REMOVING & REINSTALLING THE OVEN DOOR WARNING PERSONAL INJURY HAZARD • Use both hands to remove oven doors. 2. Close the oven door as far as the two pins will allow. 3. Grasp the sides of the door and lift the door until it stops, then pull the hinge hangers out of the slots. • Do not use the handle or any portion of the front frame or trim for lifting. • Because of the weight and size of the oven, two or more people are required to move and safely install it. Slot Failure to properly grasp the oven doors or to lift the oven properly could result in personal injury or damage to the product. CAUTION: Do not remove the shipping base or the shipping feet at the front lower corners of the oven. The shipping feet will protect the lower oven trim until the oven is inserted into the cabinet cutout. Shipping Foot To remove the oven door: 1. Install a pin in the hole of each oven door hinge hanger. Door Pin Hinge Hanger To reinstall the oven door: 1. Grasp the sides of the door and tilt it back at a slight angle, then insert the hinge hangers into the hinge slots as far as they will go. 2. Rotate the top of the door towards the oven so the hinge hangers fit onto the support pins. 3. Close the oven door as far as the pins will allow, and make sure that the hinge hangers are fully seated on the support pins. If they are not seated properly, the door will not close tightly and may be off-center. To seat the hinge hangers, open the door slightly, and push in on the bottom until the hangers are fully seated. 4. Open the oven door to its fully open position and remove the two hinge hanger pins. 5. Close the oven door completely and check it for proper operation and alignment. Door Pin Into Hinge Hanger Hole 2-3