Whirlpool GBS277PDB Technical Guide - Page 24

REMOVING THE POWER SUPPLY WIRING TERMINAL BLOCK AND THE BLOWER MOTOR WARNING ELECTRICAL SHOCK HAZARD Disconnect power before servicing. Replace all panels before operating. Failure to do so could result in death or electrical shock. 4. Remove the screw from the conduit clamp and remove the clamp. 5. Remove the 6 screws from the top rear oven cabinet cover. CAUTION: When you work on the built-in oven, be careful when handling the sheet metal parts. Sharp edges may be present, and you can cut yourself if you are not careful. 1. Disconnect the electrical power to the oven. 2. Remove the side trim from the oven (see page 4-2, steps 1 through 4 for the procedure). NOTE: Before you move the oven from its mounting location, remove the oven door to make it easier to move (see page 2-3 for the procedure). 3. Remove the oven cabinet mounting screws and pull the oven out of its mounting location so that you can access the back. Conduit Clamp Top Rear Cover (6 Screws) 6. To remove the power supply wiring terminal block: a) Remove the hex nuts from the wire terminal studs and remove the wires from the studs. b) Remove the two mounting screws from the terminal block and remove it from the top of the oven. Power Supply Wiring Terminal Block Cabinet Mounting Screw (1 Screw On Each Side) Mounting Screws Wires 4-4