Whirlpool GBS277PDB Technical Guide - Page 34
Removing The Convection Bake Element, And The Fan Motor Assembly
View all Whirlpool GBS277PDB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
REMOVING THE CONVECTION BAKE ELEMENT AND THE FAN MOTOR ASSEMBLY WARNING position the cover with the notch as shown when you reinstall it. ELECTRICAL SHOCK HAZARD Disconnect power before servicing. Replace all panels before operating. Failure to do so could result in death or electrical shock. Screw 1 of 3 Convection Cover CAUTION: When you work on the built-in oven, be careful when handling the sheet metal parts. Sharp edges may be present, and you can cut yourself if you are not careful. 1. Disconnect the electrical power to the oven. 2. To make servicing easier, remove the oven door from the unit (see page 2-3 for the procedure). 3. Remove the racks from inside the oven. Notch 5. To remove the convection bake element: a) Remove the two screws from the convection bake element. b) Pull it forward so you can access the terminals. c) Disconnect the wires from the element terminals. Screw Convection Bake Element Convection Bake Element & Fan Motor 4. Remove the three screws from the convection cover and remove the cover from the rear of the oven liner. Note the location of the notch in the cover. Be sure to Element Terminals Screw 4-14