Whirlpool GBS277PDB Technical Guide - Page 22
Removing The Oven Control/display Boards, And The Touch Panel Assembly
View all Whirlpool GBS277PDB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
REMOVING THE OVEN CONTROL/DISPLAY BOARDS, AND THE TOUCH PANEL ASSEMBLY WARNING 5. Remove the screws from the oven control panel. ELECTRICAL SHOCK HAZARD Disconnect power before servicing. Replace all panels before operating. Failure to do so could result in death or electrical shock. Control Panel Screw CAUTION: When you work on the built-in oven, be careful when handling the sheet metal parts. Sharp edges may be present, and you can cut yourself if you are not careful. 1. Disconnect the electrical power to the oven. 2. Open the oven door. 3. Remove the bottom screw from each of the two side trim pieces (see below). 4. To remove the side trim, pull the bottom out approximately 2˝, and slide the top down to free it from the control panel. 6. To remove the oven control panel, pull it out at the bottom, and lift and unhook it from the oven cabinet support at the top. Oven Control Panel Lift Off Top Support 7. Disconnect the wire connectors from the control board and set the panel assembly face down on a padded surface to protect the finish. Side Trim Screw (1 On Each Side) Pull Out Bottom Of Side Trim Pull Side Trim Down & Away From Control Panel 5 Wire Connectors 4-2