Yamaha CLP-S308PE Owners Manual - Page 86
Connect the pedal cord and power cord., Connect the power cord., Set the adjuster., Attach - reviews
View all Yamaha CLP-S308PE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
CLP-340/330: Keyboard Stand Assembly 5. Connect the pedal cord and power cord. 5-1 Pass the pedal cord from the rear and insert the plug into the pedal connector. 5-2 Attach the cord holders to the rear panel as shown, then clip the cord into the holders. 5-3 Use a vinyl tie to take up any slack in the pedal cord. PEDAL 5-1 7. Set the adjuster. Rotate the adjuster until the pedal box comes in firm contact with the floor surface. 8. Attach the headphone hanger. Use the included two screws (4 x 10 mm) to attach the hanger as shown in the illustration. ENGLISH PHONES 5-3 5-2 6-2 6-1 6. Connect the power cord. 6-1 Set the voltage selector (for models that feature a voltage selector). Voltage Selector Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a "minus" screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to the AC IN and an AC wall outlet. A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area. 6-2 Pass the power cord from the rear and insert the plug into the power connector. After completing the assembly, please check the following. • Are there any parts left over? Review the assembly procedure and correct any errors. • Is the instrument clear of doors and other movable fixtures? Move the instrument to an appropriate location. • Does the instrument make a rattling noise when you shake it? Tighten all screws. • Does the pedal box rattle or give way when you step on the pedals? Turn the adjuster so that it is set firmly against the floor. • Are the pedal and power cords inserted securely into the sockets? Check the connection. • If the unit creaks or is otherwise unsteady when you play on the keyboard, refer to the assembly diagrams and retighten all screws. CAUTION When moving the instrument after assembly, always hold the bottom of the main unit. CAUTION Do not hold the key cover or top portion. Improper handling can result in damage to the instrument or personal injury. Top portion Key cover Hold here. Do not hold here. Do not hold here. 86 CLP-370/340/330, CLP-S308/S306 Owner's Manual